Eltek Valere UNV-F 2.5 Manual de usuario descargar pdf (Pagina 28)

DC Controller

UPC4 Master

User Manual

Page 28/100

5 The menu (display operation)

Operation of the UPC4 takes place using a CAN bus-connected remote display (as option) or via remote

control using the PC software M

ulti Management Tool (MMT) alternatively.

As a standard four menu blocks are available as described as follows:

1. Measured values

2. Control functions

3. Operating status

4. System menu

Section 5.4.7 “Log in

“ describes how to log-in at the UPC4. An authorization is necessary if you want to

get access to a secured area.

5.1.1 Changing the display (leafing)

Leafing through the displays takes place by pressing the buttons "" or "". Endless leafing in both

directions is possible.

5.1.2 Changing the menu

Displays which include a selectable submenu are marked with the symbol „“. By pressing the “ENT”

button you get the submenu. Return to the superordinated menu takes place by pressing the “ESC”

button.

5.2 Measured values

In this menu block the measured data of the system is displayed according to the configuration of the

system.

Measured values:

 General:

6 x current, 6 x temperature, 6 x resistors, and 6 x voltages

 Mains:

Voltage, current and frequency (only systems equipped with mains monitoring (MM)

board)

 Power modules: REC#1→(

PSR, PSS), REC#2→(Micro-, Mini-, Flat- Powerpack), DC/DC converters,

inverters, static bypass switch (e.g. output voltage, output current, temperature)

 Power system: Syste

m voltage/-current, earth fault measurement (if activated), and the

calculated battery-, rectifier- and consumer load currents.

 Batteries: B

attery voltage, -current, center tapping voltage of the battery, and battery

temperature.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 99 100

Sin comentarios

Eltek Valere UNV-F 2.5 Manual de usuario Pagina 28