Eltek Valere UNV-F 2.5 Manual de usuario descargar pdf (Pagina 64)

DC Controller

UPC4 Master

User Manual

Page 64/100

All events which have been activated in the

list „Events history“(16.1) end up on the

history memory of the UPC4. The history

memory contains of maximum 500

messages and stores appeared as well as

disappeared events. Readout and reset of

this list takes place either directly at the

RDD and RDP respectively or via

configuration software.

The three available internal relays of the

UPC4 ar

e configured at (16.5), (16.6), and

(16.7).

The red LED "Alarm" at the front of the RD panel blinks if events of the list "Error state" (15.2) are

active. The green LED "" of the RD panel has to be parameterized at the matrix "LED OK" (16.3).

"Error state" and "LED OK" have the same content as default ex factory. But "LED OK" is inverted at

"Signals switch mode

" (see section 6.7.3). In this area (16.4) the six configurable LEDs of the RDP "LED

1 RD" to "LED 6 RD" are configured.

The relays of the Basic-Units (BU) are

config

ured at (17.1).

The relays of the optional available relay

board

s (RLB) are configured at (17.2).

16.1

16.3

16.2

16.4

16.5

16.6

16.7

17.1

17.2

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 99 100

Sin comentarios

Eltek Valere UNV-F 2.5 Manual de usuario Pagina 64