DC Controller
UPC4 Master
User Manual
Page 43/100
©2010. ELTEK VALERE DEUTSCHLAND GmbH. UM_UPC4_V2.00_E_R1.1_2011-01-04
6 Configuration – UPC4
6.1 General Information
Because direct configuration at the UPC4 control unit
(display panel) is not practice-oriented (see
section 5.5.3
) please use the PC software "Multi Management Tool" (MMT) free of charge.
The UPC4 provides an Ethernet interface (RJ45), a serial interface RS232 and optional a connection via
mode
m is possible as well.
The configuration software (MMT) works in combination with the system software Windows®
2000/
XP/2003/Vista/7. The user manual for the dial-up and general operation of this software is
optionally available (MMT user manual).
REMARK: This user manual is related to the config
uration parameters which are available for "user 1" as
default. But the configuration parameters are freely customizable.
6.1.1 Configuration of UPC systems by external modem via RS232
The UPC4 controls a connected modem via modem speci
fic commands (AT commands). The user data
are “framed” by the AT commands. Due to this the communication via Null modem cable at direct
configuration is constrained. Consequently the operation mode “modem” has to be temporary
disabled.
Both of the two possible operation modes of the modem (“started” or “stopped”) can be changed in the
m
enu “control function modem”.
1) Modem has been started.
Dialing in the system is possible. The system can be co
nfigured via modem. In this case a configuration
directly via serial interface is not possible.
2) Modem has been stopped.
Dialing in the system via modem is not possible. The modem specific commands are deactivated.
Configur
ation via a serial interface is possible.
Basically please note the following order:
1. Stop the external modem
2. Check whether the external modem has been stopped.
3. Disconnect the serial cable of the modem from the RS232 interface.
Connec
t the PC via Null Modem Cable to the UPC4.
4. Configuring of the system
5. Disconnect the Null Modem Cable, connect the serial cable to the modem.
6. Start the external modem
7. Check whether the external modem has been started/initialised
For information how to start and stop the modem, plea
se see section 5.4.6 „Control function modem“.
For information about the modem status please see section 5.3.4 „Operating status modem
“.
(192 paginas)
(78 paginas)
(80 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales